Emberglow CSO24NG Installationsanleitung PDF herunterladen (Seite 5)

CONNECTING GAS SUPPLY TO BURNER ASSEMBLY

(If a Safety Pilot Kit is to be used, please refer to seperate instructions included with the kit.)

Natural Gas applications installedwithout a Safety Pilot Kit. LP/NG Safety Pilot Kit availableat yourlocal store.

A. Place burner pan assembly in the center of the fireplace.

B. Attach 3/8” Flare X 1/2” NPT gas valve (Part #13) to the 1/2 inch gas supply stub already in fireplace.

Be certain connections are tight and use pipe compound on all male NPT (pipe) threads to seal

joints.

C. Attach 3/8” flared tubing (Part #15) to burner pan assembly.. Attach opposite end to gas supply line by

carefully bending theflared tubing as needed to make the connection. Avoid kinking thetubing while

NOTE:Agood method of bending the tube is to fill it with sand, bending the tube as needed to make the

connection.This method will eliminate kinking in the line. Once the tube is in the desired configuration,

be sure to empty the tube completely of any sand before tube is connected to the gas supply line and



Be certain all connections are tight. Only use pipe compound on all male NPT (pipe) threads.



Test all connections with a soapy water solution, and with the gas supply turned on. If bubbles appear

on any connection, tighten and re-test. Once it is determined there are no leaks whatsoever, turn off

gas supply and move to next assembly step.

GRANULE, EMBER AND GRATE PLACEMENT

A. Spread granules (Part # 16) over the installed burner pan. Granules

should be sloped to the same angle as the burner pan filling the entire

pan. (See Figure 7A.)

B. Spread glowing embers (Part # 17) evenly over the top of the granules

covering the entire surface area, concentrating on the front and sides

of the burner pan for the most realistic burning effect.

C. Place log grate (Part # 7) over the burner pan aligning as shown.

(See Figure 7B.)

D.Attach back log Standoff(Part # 18) to the back part of the grate.

(See Figure 7B.)

NOTE: A hammer may be used to tap the back log stand-off in place.

It may be necessary to squeeze the back log stand-off with pliers after

attaching to the grate.

LIGHTING YOUR GAS LOG SET

(ManualValve only)

A. Open chimney



flue damper to the full open position.

B. Be sure gas supply is shut off.

C. Lay match on top of embers and granules near gas burner input.

Do not hold match in hand (See Figure 8).

D. With match burning, slowly turn on gas.

Figure 7 ( A & B) Granule and

Grate Placement

Figure 8. Lighting the log set

bending. If tubing must be cut, use a tubing cutter. Flare the cut end of tube with a flaring tool.

burner assembly.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Emberglow CSO24NG Installationsanleitung Seite 5

Kommentare zu diesen Handbüchern